[Rpcemu] Can't get Monitor def file to work under 0.8.10/5.20

Tony Moore old_coaster at yahoo.co.uk
Mon Aug 12 10:16:02 PDT 2013


On 12 Aug 2013, George <george.greenfield at tiscali.co.uk> wrote:

> First, a massive 'thank you' to Tony Moore for exemplary instructions
> for upgrading to 0.8.10/5.20

You're welcome.

[snip]

> However, I seem to have hit a glitch with setting the screen
> resolution. I've copied across the monitor def files from a
> 0.8.10/5.17 installation and put them in
> !Boot.Resources.Configure.Monitors. However, the RISC
> OS-Configuration-Screen-Resolution available options don't go higher
> than 1280 x 1924 x 16M x 60Hz for the particular Benq MDF I'm using,
> whereas the same MDF in 0.8.10/5.17 gives the complete range up to
> 1920 x 1050, as it should, including the 1824 x 1026 'hand-made'
> option actually in use.

VIDCBandwidthLimit is set in !Boot.Choices.Boot.PreDesk.Configure.!Run
Is it different in your 0.8.10/5.17 installation? If the number of
colours is reduced, can you then see your 1824 x 1026 mode definition?

Tony






More information about the Rpcemu mailing list