[Rpcemu] RO 5.20 RPCEmu networking problem

Tony Moore old_coaster at yahoo.co.uk
Sun Aug 4 12:03:20 PDT 2013


Apologies if this appears twice. Yahoo is playing-up.

On 4 Aug 2013, Dave Symes <dave at triffid.co.uk> wrote:

> I have a couple of RPCEmu 0.8.10 installs that all Network okay, RO
> 4.20, 4.39 and 6.20.
>
> Now, as of very recently, I have a RPCEmu 0.8.10 with RO 5.20 and
> despite following the RPCEmu instructions I cannot get it to Network.

I haven't tried 5.20, but 5.21 is fine.

I suspect that your problem may be caused by the general difficulty,
reported elsewhere, in upgrading the boot from 5.1x to 5.2x. I took the
heretical route, by merging (Config > Boot > Install) the 5.21 boot with
the existing working 5.19 boot, and - apparently against the odds - all
was well. From newsgroup posts, it seems that my boot may now contain
some redundant components - but at least it works!

[snip]

> I set the configurations to be exactly the same as the other working
> RPCEmu installs with the exception of the "Internet configuration-
> Interfaces-RPCEmu: EtherRPCEm" IP address which is an unused spare.

Here, RPCEmu is installed with several operating systems, but I never
run more than one concurrently. This allows the IP address, for all
installs, to be the same. Maybe you could try setting your 5.20 IP
address, to a value known to work with one of the other installs.

Tony






More information about the Rpcemu mailing list